







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Kitchen Remodeling: The Huntington Beach Owner’s Guide
Schluter kitchen remodeling in Huntington Beach typically runs $14,000 – $45,000 installed, depending on layout, cabinet line and whether we’re retrofitting uncoupling membrane and waterproofing under existing tile. Smaller scope jobs (a cabinet run, a backsplash, an island) land far below that band, and we give you a written number before any work starts. When your Schluter system fails, you usually know it before you see it: a hollow thud walking across the kitchen floor, a grout line that keeps reappearing across the same tile, or a soft spot along the countertop edge that sponges water long after you’ve wiped it. That’s the moment most Huntington Beach owners start looking for a parts-and-install answer instead of another cosmetic patch.
Which Schluter Models This Applies To

The kitchen applications we see most in Huntington Beach fall into three families: Ditra and Ditra-Heat uncoupling membrane under tile floors, Kerdi waterproofing membrane and Kerdi-Board backer in wet zones around sinks and behind the range, and the Schluter profile and trim lines (RENO-U, SCHIENE, JOLLY) at tile edges. Identify what you have before you order anything: the orange grid face and the dovetail channels underneath tell you it’s Ditra; the fleece side and printed roll labels tell you Kerdi. Those labels matter because Ditra comes in 3/16″ and 5/16″ (Ditra-XL) thicknesses, and the wrong thickness throws off your tile-to-wood floor transition by a full quarter inch. On the waterproofing side, Kerdi and Kerdi-Band are genuinely not interchangeable – one is a sheet membrane, the other a strip for seams and corners – and homeowners routinely order the wrong one because the names look alike.
OEM versus aftermarket is where Schluter differs from most brands we deal with. The Schluter system is a system: its uncoupling, waterproofing and trim products are engineered to work as a set, and mixing in a generic membrane or a knockoff profile voids the logic of the installation even when the price looks better. For critical layers – the membrane that keeps water out of your subfloor – we spec OEM Schluter. For cosmetic trim, a quality equivalent is fine. Penhallow Remodeling Huntington Beach is an independent contractor, not affiliated with Schluter.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Kitchen Remodeling Is Failing
- Hollow or drummy tile underfoot. That empty sound means the thin-set bond between tile and membrane has let go, usually after a slab shift or a wet season of thermal movement. Once it’s hollow, the tile is on borrowed time.
- Grout cracking along one repeating line. A single crack following a seam almost always traces to a membrane or backer joint that flexed. Re-grouting hides it for a season; it comes back because the movement underneath never stopped.
- Water wicking up drywall beside the sink or range. Staining or bubbling paint at the baseboard means water got past the waterproofing layer. On the coast, our humidity and salt air make this worse across Santa Ana winds season.
- Tile edges lifting at a profile. If the trim has separated from the tile, the substrate or thin-set at that edge has moved. It’s cosmetic until moisture gets in the gap.
- Soft or springy floor near the island. A floor that gives underfoot points to a moisture-compromised subfloor under the membrane. This is the one we treat as urgent, because soft subfloor only gets softer.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Huntington Beach, expect these installed ranges. A full kitchen remodel with new Schluter membrane, substrate and tile runs $14,000 – $45,000. A small kitchen remodel sits at $9,000 – $20,000. Tile-ready cabinet installation is $4,000 – $13,000, countertop installation $2,000 – $6,500, backsplash installation $800 – $2,500, and kitchen island installation $3,000 – $10,000. What drives the number up: square footage, whether we’re tearing out and rebuilding the subfloor, and heat membrane (Ditra-Heat) if you want warm floors. What’s included every time: membrane, thin-set, tile, labor, a written line-item price before we start, and a written guarantee. Our technicians have up to 22 years of experience, and we install Cambria, Silestone and KraftMaid alongside the Schluter system where the job calls for it.
DIY or Call Us?
You can safely check a few things yourself: press a fingertip along grout lines to feel for hollow spots, look behind the sink cabinet for staining, and run a level across the floor to see if a high tile edge has lifted. That’s diagnosis, not repair. Where DIY goes wrong with Schluter is installation technique. The membrane has to be rolled into thin-set at the correct consistency with the fleece fully embedded, and a membrane that’s bonded everywhere except a pocket never shows the failure until water has been under it for months. Getting the substrate dry, flat and correctly prepped is the whole job; the tile is the easy part. If you’re seeing hollow tile or water staining, call (888) 329-8145 and let a background-checked, uniformed technician look at it before you buy parts.
FAQs

How long should a Schluter kitchen floor last? A properly installed Schluter uncoupling membrane and waterproofing system is designed to last the life of the tile above it, often 20 years or more. In Huntington Beach, the two things that shorten that are moisture intrusion from a failed sink seal and subfloor movement on older slab foundations. If it’s failing early, the cause is almost always installation or a leak, not the product.
Can the failing section be repaired instead of replaced? Often, yes. If a localized area of tile has come loose, we can sometimes lift the affected tiles, re-bond to the intact membrane and reset with matching tile. If the membrane itself is compromised or water has reached the subfloor, a tear-out is the honest answer. Call (888) 329-8145 for an exact quote – estimates are free.
How long does the repair take? A localized tile-and-membrane repair is usually a day or two. A larger kitchen remodel involving new membrane, substrate and tile runs one to three weeks depending on scope. We give you a defined arrival window and a written finish estimate before we start.
How do you source the Schluter parts? We source genuine Schluter membrane, profiles and accessories through trade suppliers, matched to the exact system your kitchen already has. We don’t stock parts on a truck or claim to; we order the correct spec for your job and confirm it before installation.
Every repair and remodel comes with our 365-Day Done Right Promise in writing: if the work fails inside the guarantee period, we come back and fix it at no charge, with a free return visit and no service call fee. A live person answers the phone, day or night.
Call (888) 329-8145 for a free estimate. Penhallow Remodeling Huntington Beach gives every homeowner a written price before any work starts, so the number on day one is the number on the invoice. If a repair fails, we come back and make it right.
Written by the team at Penhallow Remodeling Huntington Beach, serving Huntington Beach and nearby areas.












