







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cover Driveway & Pavers: The Huntington Beach Owner’s Guide
Cover driveway and paver work in Huntington Beach typically runs $7,000 – $18,000 for a paver driveway installation, $4,500 – $12,000 for concrete, and $250 – $700 for sealing, with replacement of an existing driveway in the $5,000 – $14,000 range. If you own a Cover system and a section of paving has shifted, cracked, or started holding water, you’re likely seeing a failed base or joint rather than the surface itself. Most Huntington Beach owners notice it after a winter rain: a low spot pooling near the garage apron, a paver rocking underfoot, or a hairline crack that doubled in width since summer. We install Cover-compatible driveway and paver assemblies to manufacturer spec, give you a written price before we lift a single stone, and back the work with our 365-Day Done Right Promise.
To be clear about who we are: Penhallow Remodeling Huntington Beach is an independent remodeling company. We are not affiliated with Cover, we don’t represent them, and we don’t stock their parts. What we do is install and repair Cover-compatible driveway and paver assemblies correctly, with a written number up front and a real arrival window.
Key Takeaways
- Installed paver driveways in Huntington Beach run $7,000 – $18,000; concrete runs $4,500 – $12,000.
- Base failure, not surface wear, causes most of the problems owners report.
- Seal every two to three years in our coastal climate; defer too long and the range climbs.
- We give a written price before work starts, and a written guarantee on every job.
Which Cover Models This Applies To

Cover’s driveway and paver components are sold as part of specific system configurations, and the fit is not universal across model years. The parts that matter most are the paver units themselves, the jointing or setting material, and the edging or restraint that holds the field in place. Before we quote, we identify exactly what you have.
How to identify the right part:
- Measure the field unit. Cover paver dimensions vary by series. A nominal 4×8 unit and a 6×9 unit don’t interchange in a run, and forcing a mismatch is what produces rocking edges later.
- Check the label on any surviving packaging or the stamped mark on the underside of a loose unit. Series and colorway codes are the fastest way to match a discontinued run.
- Measure the joint width. Jointing material is specified to a gap tolerance. A paver set to 1/8 inch will not accept the same joint sand as one set to 3/16 inch.
- Note the site context. A driveway apron near the street takes different restraint than a patio edge against a planter.
OEM versus aftermarket for Cover specifically: OEM parts give you an exact dimensional and color match, which matters most on a visible driveway where a mismatched patch reads as a repair. Quality aftermarket equivalents are fine where the part is buried (base aggregate, geotextile, edge restraint) and where the field won’t be visually continuous. We tell you plainly which category each part falls into. If a Cover series is discontinued and no color match exists, we say so before you commit, not after the pallets arrive.
For finishes elsewhere in the house, homeowners often ask us about KraftMaid, Cambria, and Silestone at the same time as their driveway quote. We handle those too.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cover Driveway & Pavers Is Failing
Most Cover driveway and paver failures show up as one of these five symptoms. If you can name which one you’re seeing, you’ll get a more accurate quote on the first call.
- Pavers rocking when you step on them. The bedding layer has washed out or the base wasn’t compacted to depth. Rocking accelerates joint sand loss, and once the sand goes, the whole field loosens.
- Pooling water near the garage apron or street edge. The slope has settled below the required fall, or the base was never graded to drain. In Huntington Beach, flat lots plus winter rain mean a low spot turns into a standing puddle within one season.
- Hairline cracks that widen over a season. On concrete sections, this is usually base movement or a missing control joint. A crack that opens past a credit-card width needs a look at the substrate, not just a patch.
- Efflorescence (white chalky bloom) that keeps returning. Moisture is migrating through the assembly. On pavers it can be surface residue, but recurrence after a rinse points to trapped water beneath.
- Joint sand washing out or weeds in the joints. Joint material has degraded or the wrong sand was used. Weeds are a symptom, not the problem, and pulling them widens the gap.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Huntington Beach, here are the installed ranges we work from, and they hold across our quotes:
| Scope | Installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation (for comparison) | $3,500 – $11,000 |
What moves the number: square footage, base depth and condition, whether existing material has to be hauled off, edge restraint, and whether drainage or a dry well needs to be added. What’s in the number: removal, haul-away, base preparation and compaction, the Cover-compatible field material, jointing, edge restraint, and cleanup. We don’t quote parts-plus-labor with the labor as a surprise on the invoice. Our written price before work starts is the number on the invoice, and every job comes with a written guarantee, including a free return visit if something fails.
DIY or Call Us?
You can safely check most of this yourself. Walk the field and note which units rock. Look at the slope with a straightedge or level against the garage apron. Measure any crack width. Note where water pools after rain. That information makes the quote faster and more accurate.
What you should not do yourself: reset a paver field without addressing the base, or pour a patch over a moving slab. The surface is the part you see; the base is the part that fails. Patching over a base that’s still moving means the same crack returns within a season. On any load-bearing driveway apron near the street, base depth and compaction are what keep the assembly from settling, and getting those wrong is invisible until the first wet winter. Removing and recompacting a base is also heavy work, and a vehicle parked on a half-set field can undo it. We’d rather you call than hurt your back or your driveway.
Call (888) 329-8145 and a real person will answer, any time, and schedule a free written estimate.
FAQs

A properly installed paver driveway in our climate typically holds 20 to 30 years on a compacted base, with sealant reapplied every two to three years; concrete runs 25 to 30 years with good drainage. The base is what determines lifespan, not the surface. In Huntington Beach, salt air and seasonal rain speed up joint-sand loss, so resealing on a two-year cycle rather than a four-year one is realistic near the coast. Call (888) 329-8145 for an exact quote on your driveway, estimates are free.
Often yes. Localized rocking, a settled apron, or a single cracked slab can be lifted and reset or replaced in isolation if the surrounding base is sound. We check the base first, because repairing the surface over a bad base just moves the failure. Call (888) 329-8145 and we’ll tell you honestly whether it’s a repair or a replacement.
A localized paver reset is usually a one- to two-day job; a full paver driveway replacement in Huntington Beach typically takes three to six days, depending on square footage, base depth, and whether old material has to come out. We give you a written start date and a real arrival window, and we keep to both. Call (888) 329-8145 to get your written price before any work starts.
We source through recognized manufacturers and trade suppliers, matching your Cover series by measurement and stamped mark, and we tell you up front whether a matching OEM part is available or whether a quality aftermarket equivalent is the honest option. We don’t claim to stock Cover parts, and we carry no parts on a truck. What we do is source the right assembly, install it to spec, and stand behind the work with our 365-Day Done Right Promise. Call (888) 329-8145 to schedule your free estimate.
Written by the team at Penhallow Remodeling Huntington Beach, serving Huntington Beach and nearby areas.












