







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Home Additions & ADU: The Huntington Beach Owner’s Guide
This page covers the sliding door and window assemblies Mr-Glass uses in residential additions and accessory dwelling units, and the repair and replacement patterns we see across Huntington Beach. Home additions and ADU construction typically fall in the $45,000 – $130,000 and $90,000 – $220,000 ranges respectively, depending on the footprint, the foundation work, and how the glazing is spec’d. There’s no same-day install here: this is a scheduled build, planned weeks out, with permits.
Huntington Beach sits close enough to the coast that the Mr-Glass units installed in older additions have usually lived through years of salt air, morning marine layer, and the occasional Santa Ana hot snap. When those units start to fail, it shows up slowly: a door that won’t slide evenly, a fogged pane you can’t wipe clear, water staining the interior sill after a windy rain. Owners tend to notice it in the third or fourth week of summer, right when the marine layer burns off and the interior starts running hot.
Which Mr-Glass Models This Applies To

Mr-Glass makes residential glazing across several product families, and the part you need depends entirely on which family landed in your addition or ADU. The two you’ll run into most in Huntington Beach are the roller-and-track sliding systems used for patio doors and the fixed or operable window units in the unit’s light wells.
The fastest way to identify what you have: look at the manufacturer’s label on the door frame or the sash edge, usually a small sticker or a stamped mark with the series designation and a model number. If the label is gone, measure the visible glass depth, the track width, and the door leaf thickness. Those three numbers will usually match a replacement part even when the original paperwork is long gone.
On the OEM-versus-aftermarket question, the honest answer for Mr-Glass in an addition or ADU is that quality aftermarket parts are fine for the high-wear bits: rollers, weatherstrip, track guides, and seals. For the glass itself, especially if the unit carries a low-E coating or a specific tint, match the specification closely or the coating warranty on that glass panel won’t transfer cleanly. We’re an independent service provider, not affiliated with Mr-Glass, so we source what the unit actually needs rather than what a single supply chain pushes.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Home Additions & ADU Is Failing
A failing unit rarely fails all at once. Here’s what we look for on a Huntington Beach home:
- The door drags or jumps the track. Worn rollers, a bent lower track, or both. On salt-air homes the roller housings corrode faster than inland, so the roll gets stiff before it gets loud.
- Fogging between the panes. That’s a failed seal in an insulated glass unit. No cleaner fixes it; the IGU has to be replaced because moisture has already gotten into the airspace.
- Water at the interior sill after rain. Usually a failed weatherstrip, a clogged weep channel, or a perimeter seal that’s given up. Left long enough, it reaches the framing.
- Persistent draft or heat gain. The glass spec has degraded or the unit no longer seals tight at the operable edge. In an ADU that runs warm in summer, this one shows up hard.
- Hardware that won’t latch, or a door that won’t sit square. Hinge or lock failure, or the wall has moved and the door has to be re-set. This one is worth a look because it can signal something structural.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Rebuilding or repairing the glazing in an addition or ADU is rarely a single line item, so the price depends on what’s actually failing. Here’s where our Huntington Beach work lands:
- Replacing a failed sliding door or window unit within an existing addition: $4,500 – $15,000
- A full home addition (including new glazing throughout): $45,000 – $130,000
- A full ADU build: $90,000 – $220,000
- A garage-to-ADU conversion: $30,000 – $80,000
What drives the range: the number of units, whether the new units require framing or a header rebuild, whether the glass spec is a standard clear pane or a coated and tinted one, and whether we’re correcting old water damage while we’re in there. We give you a written price before any work starts, itemized by part and labor, so the number you sign is the number you pay. Every job carries our 365-Day Done Right Promise and a written guarantee on the work.
DIY or Call Us?
There are safe things you can check on your own. Walk the door track, run your finger along the weatherstrip, look for fog between the panes, and note where water is showing up. Those observations help us quote honestly and save everyone a trip. Replacing rollers, swapping out weatherstrip, and cleaning weep channels are also fair game if you’re comfortable on a ladder.
Where DIY goes wrong on glazing in an addition or ADU: pulling a sealed unit and re-setting it without knowing the original glass spec, or attempting a wall or header modification to fit a new door and discovering the load path isn’t what you thought. That’s when a job for one weekend turns into structural repair. Glass that fails can also shatter, and an insulated unit carries real weight. If the fix involves anything beyond the movable hardware, give us a call at (888) 329-8145. A live person answers around the clock, and estimates are free.
FAQs

Roughly 20 to 30 years for a good insulated unit, though the salt air and moisture of Huntington Beach tends to shorten that window for the seals and hardware. Rollers and weatherstrip often need replacing around year 10 to 15, while the glass itself can run longer. Our technicians have up to 22 years of experience and can tell you how much life is left in your specific unit.
Yes, often. Failing rollers, weatherstrip, track guides, and locks are all replaceable individually, and that’s the cheaper fix when the glass is still sound. Fogged insulated glass units and cracked panes require a full glass-panel replacement, but the surrounding frame and hardware can usually stay. We’ll tell you which side of that line you’re on before any work is priced. Call (888) 329-8145 for a free estimate.
A single unit swap runs a half day to a full day, depending on whether the opening needs re-framing or just re-setting. A larger project involving multiple units in an addition will schedule over several days so we’re not cutting and sealing all at once. You’ll get a written arrival window before we start, and we leave the space cleaner than we found it.
We start from the label on the frame or sash, and if it’s missing, from the measured glass depth, track width, and door leaf thickness. That identifies the product family, and from there we match roller, weatherstrip, and glass specification to what the unit was built for. We source from recognized industry brands, including KraftMaid, Cambria, and Silestone for interior finishes around the unit. Our technicians arrive background-checked and in uniform, and every repair carries a written guarantee with a free return visit if it fails.
Ready for a written price on your addition or ADU glazing? Call (888) 329-8145 to schedule your free estimate. We serve Huntington Beach and the surrounding neighborhoods, and a real person picks up any time of day.
Written by the team at Penhallow Remodeling Huntington Beach, serving Huntington Beach and nearby areas.












